CWNP CWDP-305 Übungsprüfungen
Zuletzt aktualisiert am 06.06.2025- Prüfungscode: CWDP-305
- Prüfungsname: Certified Wireless Design Professional
- Zertifizierungsanbieter: CWNP
- Zuletzt aktualisiert am: 06.06.2025
Name the audience type not addressed in this chapter for HLDs.
- A . Operations
- B . Executives
- C . Designers
- D . Engineering
When selecting a centralized WLAN architecture, what new problem may arise when you change the data forwarding model from centralized to distributed?
- A . Centralized control functions, such as key management and distribution, RRM, and load balancing will no longer be supported.
- B . The router between the APs and the controller must be made aware of the APs as forwarding client STAs.
- C . APs that were designed for a centralized forwarding model may not support all features in distributed forwarding mode.
- D . All RRM controls will also need to be distributed to a master AP that acts as a channel and transmit power arbiter for other APs in the ESS.
If radar has reportedly been detected on your WLAN deployment, what bands would you consider avoiding?
- A . 5 GHz UNII-2 and 2e
- B . 5 GHz UNII-2 and 3
- C . 5 GHz UNII-2, 2e, and 3
- D . 5 GHz UNII-1 and 2
- E . 5 GHz UNII-1, 2, and 3
What important item is often left out of operational and maintenance plans?
- A . Syslog analysis
- B . Network overview
- C . Engineering feedback
- D . Configuration backups
Given: For this fill-in the blank question, each answer option contains an answer for the first and second blanks, separated by a dash "―". Choose the answer option that correctly fills in both blanks in the following sentence.
A WLAN may use 802.11 admission control to ________, and admission control requirements are configured separately for each ________.
- A . Block stations with inadequate security parameters ― SSID
- B . Identify voice-enabled wireless devices ― AP radio (that is, 2.4 GHz or 5 GHz)
- C . Regulate the available bandwidth resources ― Access Category
- D . Mark ingress and egress frames with priority values ― TCP/IP port
An amplifier has a 1 dB compression point of 32 dBm and a gain of 20 dB.
Which is the highest average input power shown here that would be safe to operate a 24 Mbps 802.11g signal so that spectral regrowth is not a problem?
- A . 5 dBm
- B . 0 dBm
- C . 5 dBm
- D . 10 dBm
What type of protection should be provided to outdoor antenna installations?
- A . Static electricity
- B . Brownouts
- C . Lightning surge suppression
- D . A/C spikes
When preparing a floor plan graphic for use in predictive and manual site surveying, what calibration method will lead to the most accurate and reliable RF data?
- A . Use the known size of a small object, such as a ceiling tile, and use a single instance of this object (e.g. a single ceiling tile) to scale the floor plan.
- B . Measure the width of an actual office doorway with a tape measure and use this value to calibrate against a doorway graphic.
- C . Use the longest available measurement (like a straight exterior wall) to calibrate the graphic’s scale.
- D . Calibrate the ceiling height of the floor plan first, then the survey software should be able to auto-calibrate the X and Y planes of the graphic.
When implementing WLAN security according to common best practices, what feature should be enabled when configuring an EAP type?
- A . The "Use WEP if RADIUS server unavailable" option
- B . The "Validate server certificate" option
- C . The "Trusted Root Certification Authorities" list
- D . The "Do not prompt user to authorize new servers or trusted certification authorities" option
You performed a site survey with two USB Wi-Fi adapters using a special driver written for the site survey software. After deployment, you realized that the client devices used by your customer are getting lower RSSI values than that shown during your site survey.
What is the most likely reason for this result?
- A . USB Wi-Fi adapters designed for site surveys may have better sensitivity than regular Wi-Fi cards installed in client devices.
- B . The transmit power on the APs is higher than needed.
- C . Regular Wi-Fi cards installed in client devices do not support the same protocols as survey adapters.
- D . USB Wi-Fi adapters have a greater sensitivity than internal Wi-Fi adapters.