HP HPE7-A01 Übungsprüfungen
Zuletzt aktualisiert am 06.05.2025- Prüfungscode: HPE7-A01
- Prüfungsname: Aruba Certified Campus Access Professional Exam
- Zertifizierungsanbieter: HP
- Zuletzt aktualisiert am: 06.05.2025
How is Multicast Transmission Optimization implemented in an HPE Aruba wireless network?
- A . "The optimal rate for sending multicast frames is based on the highest broadcast rate across all associated clients
- B . When this option is enabled the minimum default rate for multicast traffic is set to 12 Mbps for 5 GHz
- C . The optimal rate for sending multicast frames is based on the lowest broadcast rate across all associated clients.
- D . The optimal rate for sending multicast frames is based on the lowest unicast rate across all associated clients.
A network administrator is troubleshooting some issues guest users are having when connecting and authenticating to the network The access switches are AOS-CX switches.
What command should the administrator use to examine information on which role the guest user has been assigned?
- A . show aaa authentication port-access interface all client-status
- B . show port-access captiveportal profile
- C . show port-access role
- D . diag-dump captiveportal client verbose
What is an OSPF transit network?
- A . a network that uses tunnels to connect two areas
- B . a special network that connects two different areas
- C . a network on which a router discovers at least one neighbor
- D . a network that connects to a different routing protocol
What is used to retrieve data stored in a Management Information Base (MIS)?
- A . SNMPv3
- B . DSCP
- C . TLV
- D . CDP
Match each PoE power class to Its corresponding 802.3 standard. (Options may he used more than once or not at all)
The administrator notices that wired guest users that have exceeded their bandwidth limit are not being disconnected Access Tracker in ClearPass indicates a disconnect CoA message is being sent to the AOS-CX switch.
An administrator has performed the following configuration
What is the most likely cause of this issue?
- A . Change of Authorization has not been globally enabled on the switch
- B . The SSL certificate for CPPM has not been added as a trust point on the switch
- C . There is a mismatch between the RADIUS secret on the switch and CPPM.
- D . There is a time difference between the switch and the ClearPass Policy Manager
A company recently upgraded its campus switching infrastructure with Aruba 6300 CX switches. They have implemented 802.1X authentication on edge ports where laptop and loT devices typically connect. An administrator has noticed that for PoE devices the pons are delivering the maximum wattage instead of what the device actually needs Upon connecting the loT devices, the devices request their specific required wattage through information exchange
- A . Concerned about this waste of electricity, what should the administrator implement to solve this problem?
- B . Enable AAA authentication to exempt LLDP and/or CDP information
- C . Globally enable the QoS trust setting for LLDP and/or CDP
- D . Create device profiles with the correct power definitions.
- E . implement a classifier policy with the correct power definitions.
A customer wants to deploy a Gateway and take advantage of all the SD-WAN features .
Which persona role option should be selected?
- A . ArubaOS 10 Branch
- B . ArubaOS 10 VPN Concentrator
- C . ArubaOS 10 Wireless
- D . ArubaOS 10 Mobility
A customer is using stacked Aruba CX 6200 and CX 6300 switches for access and a VSX pair of Aruba CX 8325 as a collapsed core 802 1X is implemented for authentication. Due to the lack of cabling, some unmanaged switches are still in use Sometimes devices behind these switches cause network outages The switch should send a warning to the helpdesk when the problem occurs You have been asked to implement an effective solution to the problem.
What is the solution for this?
- A . Configure spanning tree on the Aruba CX 8325 switches Set the trap-option
- B . Configure loop protection on all edge ports of the Aruba CX 6200 and CX 6300 switches No trap option is needed
- C . Configure loop protection on all edge ports of the Aruba CX 6200 and CX 6300 switches Set up the trap-option
- D . Configure spanning tree on the Aruba CX 6200 and CX 6300 switches No trap option is needed
You need to ensure that voice traffic sent through an ArubaOS-CX switch arrives with minimal latency What is the best scheduling technology to use for this task ? (Select two.)
- A . Voice VLANs can be automatically configured for VoIP phones
- B . APs can request power as needed from PoE-enabled switch ports
- C . iSCSl client devices can request to have flow control enabled
- D . GVRP VLAN information can be used to dynamically add VLANs to a trunk
- E . iSCSl client devices can set the required MTU setting for the port.