What are the considerations when using existing MMF and upgrading to equipment capable of 10 GbE speeds? (Select two)

Lösung einblenden Lösung ausblenden

What is a primary benefit of deploying Aruba’s SD-Branch solution in a distributed enterprise environment?

Lösung einblenden Lösung ausblenden

Matchthe deployment typeto the estimated numberof APs.

Lösung einblenden Lösung ausblenden

Richtige Antwort:

Explanation:

Capacity based design with low to mid density – 100,000 ft² / 900 m² building 100,000/10,000 = 10 Aps

Coverage based design – 100,000 ft² / 900 m² building 100,000/2,500 = 40 APs

High-capacity design – 100,000 ft² / 900 m² building 100,000/1,500 = 67 APs

Very low-density, low coverage – 100,000 ft² / 900 m² building 100,000/500 = 20 APs

The deployment of Access Points (APs) in a wireless network design depends on the required density and coverage needed:

Capacity based design with low to mid densityis often used in environments like office spaces where there is a moderate amount of users and devices. Fewer APs are required compared to high-density scenarios.

Coverage based designtypically requires more APs than a low-density capacity design because the goal is to provide a wireless signal to all areas, regardless of the number of users.

High-capacity designis for environments like stadiums or conference centers where a high number of users are expected to be concentrated in a particular area. Thus, a higher number of APs is needed to accommodate the user load.

Very low-density, low coverageis suitable for areas that have few users over a large space, such as warehouses or outdoor areas. Fewer APs are required as the focus is on covering space rather than supporting a large number of devices.

Which Aruba solution integrates with Microsoft Office 365 to optimize cloud application performance?

Lösung einblenden Lösung ausblenden

What is the primary purpose of Aruba UXI sensors?

Lösung einblenden Lösung ausblenden

A large multinational financial institution has contracted you to design a new full-stack wired and wireless network for their new 6-story regional office building. The bottom two floors of this facility will be retail space for a large banking branch. The upper floors will be carpeted office space for corporate users, each floor being approximately 100.000 sq ft (9290 sqm). Data centers are all off site and will be out of scope for this project. The customer is underserved by its existing L2-based network infrastructure and would like to take advantage of modern best practices in the new design. The network should be fully resilient and fault-tolerant, with dynamic segmentation at the edge.

The retail space will include public guest Wi-Fi access. Retail associates will have corporate tablets for customer service, and there will be a mix of wired and wireless devices throughout the retail floors. The corporate users will primarily use wireless for connectivity, but several wired clients, printers, and hard VoIP phones will be in use.

The customer is also planning on renovating the corporate office space in order to take advantage of "smart office‘ technology. These improvements will drive blue-dot wayfinding. presence analytics, and other location-based services

The client decided that they would like to manage two wiring closets as a single stack with a total of 10 switches and a minimum transport speed or 25Gbps over OM4 MM fiber They would also like to keep the stacking cabling cost to a minimum.

Which stacking components would be required to meet the customer’s requirements in the most cost-effective way if the closets were 190 m (620 ft) apart? (Select two.)

Lösung einblenden Lösung ausblenden

ACME retail has 38 locations spread out across Ave US states and two provinces in Canada. They are looking to grow 20% over the next two years. They have an HO with a staff of 200 employees. The organization has eight Regional Managers and two VPs who work from home and the road. Stores typically have 17 employees on average per location.

The two warehouses have a remote loading system and 20 employees each to load the trucks and fulfill the online orders. The warehouse has 40-foot ceilings and large metal racks to store inventory. The main location is 240K sq ft (22300 st) m) and the Canadian warehouse Is 130K sq ft (12100 sq ml. The forkllfts on the loading docks are equipped with a wireless tablet on board.

A typical store Is reportedly about 60.000 sq ft (5575 sqm) and smaller stores are planned at 25.000 sq ft ‚2320 sq mi. The locations need to expand the abilities to vendors that need to add setup displays or Interactive kiosks in the stores. The current Infrastructure was installed In 2015 and used wireless N technology in a coverage model. The wiring is CatS. and they are unsure of the fiber connections. The inventory is all placed on the floor when it is delivered to the local store.

Inventory control is handled through Zebra barcode scanners, and they have had a lot of issues in getting signals throughout the stores and this makes monthly inventory difficult. The organization has a small help desk to troubleshoot issues that happen at the retail locations and PC support for the office. The company is looking to upgrade away from the current pbx system later this year. With the need to grow and cut costs, they are interested in moving the data to the cloud but need to get almost real-time inventory control for the online service to function.

The network has all been wired over the last ten years, but with the new systems being all wireless, they have seen the trend to offer wireless to all the vendors for their needs but also would like to allow employees, guests, and contractors all to use it. With the new IT director starting next week, the project has been set by the CTO of the company. The marketing group has asked how they can interact with the customers and get more info, while the IT support desk needs to cut staff in halt.

The. office has an MDF and two IDFs located on floors one and two. The HOF is in the basement, and you have multiple WAN circuits for the HO links. Each store has a local handoff from the cable company (ethernet) In the middle of the store in the office, so distance for the wiring is not an issue.

The customer has budget concerns but does want something that could last 7+ years.

Based on the best practices and customer requirements, what is the correct WLAN approach?

Lösung einblenden Lösung ausblenden

A large multinational financial institution has contracted you to design a new full-stack wired and wireless network for their new 6-story regional office building. The bottom two floors of this facility will be retail space for a large banking branch. The upper floors will be carpeted office space for corporate users, each floor being approximately 100.000 sq ft (9290 sqm). Data centers are all off site and will be out of scope for this project. The customer is underserved by its existing L2-based network Infrastructure and would like to take advantage of modern best practices in the new design. The network should be fully resilient and fault-tolerant, with dynamic segmentation at the edge.

The retail space will include public guest Wi-Fi access. Retail associates will have corporate tablets for customer service, and there will be a mix of wired and wireless devices throughout the retail floors. The corporate users will primarily use wireless for connectivity, but several wired clients, printers, and hard VoIP phones will be In use.

The customer is also planning on renovating the corporate office space in order to take advantage of "smart office‘ technology. These improvements will drive blue-dot wayfinding. presence analytics, and other location-based services.

The client has decided that more critical switch stacks supporting Contact Center resources will need to

support greater than 600W of CL4 PoE and have redundant power supplies These stacks will have approximately six members.

What would be the most economical choice Aruba switch series to meet these requirements?

Lösung einblenden Lösung ausblenden

Which solution would you deploy to manage policy enforcement and network authentication across a wired and wireless Aruba environment?

Lösung einblenden Lösung ausblenden

What is one use case for designing a 2-tier campus LAM instead of using a 3-tier?

Lösung einblenden Lösung ausblenden