Huawei H12-323_V2.0-ENU Übungsprüfungen
Zuletzt aktualisiert am 23.10.2025- Prüfungscode: H12-323_V2.0-ENU
- Prüfungsname: HCIP-WLAN V2.0
- Zertifizierungsanbieter: Huawei
- Zuletzt aktualisiert am: 23.10.2025
In a high-density WLAN scenario, the signal-to-noise ratio detected by the terminal must reach at least () dB to ensure a balance between bandwidth rate and signal coverage.
Wireless network capacity optimization needs to consider the service types and user models of customers in different scenarios, and provide customers with capacity optimization suggestions based on network construction standards. When a customer has 300 users accessing the existing network, the concurrency rate is 40%, the average bandwidth of a single user is 16Mbps, and the terminal bandwidth of the currently selected AP is 16 Tlbpsi, the number of concurrent terminals is 15, then in order to meet the capacity requirements, () APs need to be deployed in the area.
An engineer enabled the intelligent roaming policy in the WLAN network, hoping to improve the user experience.
When configuring the triggering method of smart roaming, which of the following methods can be configured? (Multiple choice)
- A . Triggered when the detection terminal SNR is lower than the set threshold
- B . Detect terminal channel usage reaching a threshold trigger
- C . Detection terminal RSSI reaches a high value trigger
- D . Trigger when the terminal rate is lower than the set value
When planning the network for the stadium stand area, which of the following scenarios is suitable for deploying APs using a combination of edge and ceiling coverage?
- A . The maximum number of seats in a single-tier stand is no more than 20 rows
- B . The maximum number of seats in a single-tier stand is no more than 30 rows
- C . Scenario with more than 30 rows of seats in a single-tier stand
- D . The maximum number of seats in a single-tier stand is no more than 25 rows
In dormitory scenarios, panel APs are generally used and wall-mounted. The figure below shows the network planning scheme for dormitory scenarios. Which of the following schemes is the most reasonable?
- A . Option C
- B . Plan A
- C . Plan D
- D . Plan B
An engineer is deploying a wireless network. Guest access uses Portal authentication, the authentication point is the wireless controller, and the authentication server uses iMaster NCE-Campus.
The contents of the Portal server template configured on the wireless controller are as follows. Which of the following descriptions of the configuration are correct? (Multiple choice)
- A . The IP address for communication between the device and the Portal server is 10.10.10.254
- B . The IP address of the Portal server is 10.23.200.1
- C . The port number for processing Portal protocol packets on the device is 50200
- D . The URL redirected to the user will contain the ssid name
With the development of Wi-Fi technology, WLAN network has become one of the main means of enterprise network access, and users have higher requirements for the experience of WLAN network.
A newly deployed WLAN network needs to be optimized at the most basic level. Which of the following aspects can be used to optimize the network? (Multiple choice)
- A . Power
- B . Terminal Migration
- C . Channel
- D . Traffic
During project deployment, when the remote access unit R240D is installed beyond the PoE power supply distance, a switch can be used for expansion.
- A . True
- B . False
The display ap all command can be used to view the AP’s MAC, Type, and operating status.
- A . True
- B . False
Which of the following descriptions about dynamic load balancing used in high-density scenarios is correct? (Multiple choice)
- A . Load balancing is applicable to high-density wireless network environments to effectively ensure the reasonable access of STAs. The purpose of 5G priority access within four APs is to reduce the 2.4CHz load and improve the overall performance of the system.
- B . Load balancing between APs, load balancing based on the number of access users or traffic, optimizes the distribution of terminals in the entire network and improves user experience
- C . APs with load balancing enabled must be connected to the same AC, and STAs can scan the SSIDs of APs that perform load balancing.
- D . Dynamic load balancing can be divided based on the number of users, traffic, and business type.