Huawei H12-323_V2.0-ENU Übungsprüfungen
Zuletzt aktualisiert am 24.10.2025- Prüfungscode: H12-323_V2.0-ENU
- Prüfungsname: HCIP-WLAN V2.0
- Zertifizierungsanbieter: Huawei
- Zuletzt aktualisiert am: 24.10.2025
In a WLAN network, if you want to configure the spectrum navigation function, the AP is required to support both the 2.4G band and the 5G band, and the two radio frequencies must use the same () and security policy.
When using WLAN Planner to deploy equipment, you can double-click the AP to set the azimuth and downtilt angle of the directional antenna. The maximum downtilt angle can be set to () degrees.
In WLAN network intelligent operation and maintenance, CampusInsight southbound interface realizes the connection between CampusInsight and devices and completes CampusInsight’s management function on devices. Which of the following southbound interface types are supported by CampusInsight? (Multiple choice)
- A . Syslog
- B . FTP
- C . HTTP/2+ProtoBuf
- D . SNMP
In WLAN site survey, which of the following statements is correct regarding the need to confirm the AP installation location and related equipment installation in coverage scenarios? (Multiple choice)
- A . If the weak current well is too far from the AP installation location, the switch cannot be installed.
- B . Indoors, you need to confirm the installation location of the AP and the indoor antenna, and the AP installation method, such as wall-mounted, ceiling-mounted, or placed in the ceiling.
- C . Confirm the location of the data center, which is the general gathering point where AC, network management and various servers are usually placed.
- D . Outdoors, you need to confirm the installation location of the AP and outdoor antenna, and whether a pole is needed.
In WLAN network planning in crowded scenarios such as lecture halls or banquet halls, due to the large number of concurrent users, engineers will give priority to APs with fewer MIMOs but more radio frequencies when selecting AP models.
- A . True
- B . False
During the troubleshooting process of VRRP hot backup establishment failure, you can use the display hsb-service command to check whether the HSB channel between the active and standby WACs is normal. If the service status queried is (), it means that the HSB link is not connected.
In WLAN network planning, signal coverage design is used to ensure that the signal strength within the coverage area of each area can meet user needs while solving interference problems between adjacent APs.
So according to the signal coverage design principles, engineers should consider the following when designing signal coverage? (Multiple choice)
- A . AP power supply mode
- B . Signal attenuation due to obstacles
- C . AP deployment location
- D . Single AP coverage
In WLAN network planning, when measuring coverage, the AP uses different antennas and the measurement method is different. If the AP uses an omnidirectional antenna, the coverage distance is used for measurement; if the AP uses a directional antenna, the coverage radius is used for measurement.
- A . True
- B . False
In VRRP hot standby networking, in order to simplify the command line configuration of the standby WAC, you can enable the wireless configuration synchronization function. Through the wireless configuration synchronization function, the active VAC can use the HSB active-standby channel to synchronize the public wireless configuration to the standby WAC.
- A . True
- B . False
The WLAN network of a certain enterprise headquarters adopts WAC+FIT AP networking mode, and the branch adopts Leader AP networking mode. Now the headquarters is required to uniformly manage the WLAN network of the branch, so the Leader AP of the branch needs to be switched to FIT AP.
- A . True
- B . False